CN 
EN
Introduction to the
Touch static elimination ball, its appearance is made of stainless steel tubes and stainless steel ball, it is suitable for chemical industry, metallurgy, military industry, oilfield, petrochemical, gas station, electric power, electronics, railways, mining and gas extraction, fireworks, computer rooms, senior hotel, senior office potential HuoHuan and explosion dangerous environment medium inflammable and explosive places. The principle of the circuit is basically the same as others, and its biggest characteristic is that it can work normally at -50~100℃.
cc
Medical research confirms: the human body accumulates static electricity to harm health: some people skin allergy, rhythm of the heart is maladjusted, have a headache insomnia, and be agitated wait for a symptom, still have the person hair to stand firm, mental tension. Fear of touching metal objects. In addition, when the body is accumulating static electricity when touching the computer will make the computer crash, electronic components breakdown, flammable ignition and other hazards
Method of use and installation
Installation method: the total height is 1 meters, with a base, first Φ10 screws into the ground weld, through the base screw on the stainless steel pipe bottom nut. Put on the ground wire and the installation will be complete. Touch the ball to remove the static electricity from the human body. The grounding wire should be connected to the lead wire of the ground wire with multiple strands not less than 0.3 square meters. Other parameters are the same as above.
There is a hole in the ball seat, the hole has electrostatic indicator light, if there is static electricity in your body, just touch the metal ball above with your finger (one second) can eliminate the static electricity in your body, (the indicator light is lit and then off). It's obvious at night, not so obvious during the day. If the body static electricity is less than 100V or there is no static electricity, the static indicator light is not on.
maintenance
When moving the white steel pipe before installation, it should be handled gently. This is because there are circuit elements in the steel pipe, and the steel pipe does not enter debris, especially metal objects, such as metal objects. The circuit can not work normally. Because the sphere is insulated from the steel tube, no other metal can be near the sphere.
Matters needing attention
1. The device must be connected and installed with the material connected to the ground wire.
2. In the process of installation, conditions must be met to avoid open fire construction and avoid accidents.
3. Before installation, it is necessary to check whether there is any damage to the semi-guide touch body and the connecting part, and it is strictly prohibited to install and use the damaged point.
4. The minimum point of static electricity generated by human body will be higher than oil vapor (0.2MJ) every 25 meters in the normal process of human body walking. It is recommended to install one piece of this product every 25 meters
5. In the normal use process, keep the contact between the human body and the semi-conductive touch body for 10-15 seconds to achieve the purpose of the safe release of static electricity.
6. Keep the explosion-proof electrostatic release touch body clean during use.